Oil pump
Posted: Tue Dec 22, 2009 3:37 pm
I heard some where about the stock oil pump on a SOHC r/t not flowing enough oil to the srt turbo, what can I do to solve this problem when I run my car with the srt turbo setup?
Page 1 of 1
Posted: Tue Dec 22, 2009 8:54 pm
Well, mine's been flowing well enough to supply to my s362 and still keep over 50psi of oil pressure. I suppose you could get a melling, but I'm not sure why.
Posted: Wed Dec 23, 2009 1:23 am
In the sticky it says you need to replace the oil pump. Obviously that needs to be updated since it's wrong...it says in huge fucking red letters 
ONE MORE THING, YOU MUST UPGRADE YOUR OIL PUMP. YOUR STOCK OIL PUMP WILL GO OUT ON YOU IF YOU TRY TO RUN IT WITH YOUR TURBO SET-UP
Posted: Wed Dec 23, 2009 10:11 am
Good catch, Adionik. I made a little correction. 
Posted: Wed Dec 23, 2009 12:59 pm
this thread was very helpful to me as well!!
Posted: Wed Dec 23, 2009 4:19 pm
i have been running a stock oil pump on mine as well... been running good for several years
Posted: Wed Dec 23, 2009 5:58 pm
I forgot to throw my two cents in after I made the edit...
I ran the stock oil pump on my boosted 2.0 and the current boosted 2.4. It worked just fine.
I ran the stock oil pump on my boosted 2.0 and the current boosted 2.4. It worked just fine.
Posted: Wed Dec 23, 2009 6:28 pm
Why was it ever said than? That guy must have had excessive detonation or something...
Posted: Wed Dec 23, 2009 7:54 pm
Thanks for the comments everyone. Very helpful.
Posted: Wed Dec 23, 2009 8:18 pm
Unless he was thinking of running UDP, but even then pump failures are rare, unless serious power is being made. A little more required volume isn't going to harm the pump, just relax the pressure relief spring a little. The pump rotor won't know the difference. It is still going to pump the same volume, just less of that volume will go through the bypass.Adionik wrote:Why was it ever said than? That guy must have had excessive detonation or something...