Posted: Thu Sep 21, 2006 9:05 pm
Same height, doesn't hang down any lower than the stocker.
See now that's what I was after. I know it's gasket in a tube, but those locations to pay attention to are very important. Thanks J.Diablo0 wrote:Jesus, old thread! lolsatrnbmb wrote:Not to totally bring this back from the dead, but what do you use for a gasket and what's this RTV stuff? I've got a crank scraper I want to install.
You can reuse your stock gasket as it's made with rubber and can be reused as long as you don't damage it in pulling it off. I myself bought another gasket to play safe and the RTV is used to seal where I wanna say the bed plate meets the oil pump assembly. There is a little joint there where oil can seap out if RTV isn't used. It's like a liquid gasket that hardens into a rubber of sorts.
