Page 1 of 1
Gasket Material?
Posted: Fri May 05, 2006 4:19 pm
by Neonix
This is probably in the wrong section (Sorry Jason) but if I were to make a gasket, which material would be best to use? Is there even a difference?
Thanks guys!
Posted: Fri May 05, 2006 4:27 pm
by cnfx-wicked
where is the gasket to be used, what material depends on the location
Posted: Fri May 05, 2006 4:33 pm
by Neonix
From the header to the downpipe. I have the gasket for the header to the engine.
Posted: Fri May 05, 2006 4:36 pm
by dinetuner
paper... or aluminimun... or check that new metal they now make struts out of... check in the suspension forum...hehehe
Posted: Fri May 05, 2006 4:47 pm
by Neonix
Ok. I'll just have to go to the parts store and look. Thanks!
Posted: Sat May 06, 2006 3:59 am
by dblsg
high temp RTV. that should work.