2GN.ORG

Does anyone have a strut laying around that has the sway bracket welded on? I need the measurements between the 2 bolts holding the strut onto the knuckle, and the measurements how much lower the bracket is than the bottom bolt, as well as the offset to the inside.
I'm cutting a set of brackets for another 2gn to bolt in a sway.

I used a 1st gen rear bracket and a piece of angle iron. It was a cheap fix at $13 each.

If possible could you send me more detailed pics of your setup jmr?

Thanks

You could always buy a set of mine

http://forum.2gn.org/viewtopic.php?t=19840