Page 1 of 1
rear hubs
Posted: Sun Aug 26, 2007 5:08 pm
by Arro
Are the rear hubs from an SRT-4 interchangeable with a drum setup, or does the drum use a different type?
Posted: Mon Aug 27, 2007 4:03 am
by deep1ca
srt-4 rear hubs are different then rear hubs with drums from other neons.....atleast for -02, not sure about 03+ neons.
Posted: Mon Aug 27, 2007 10:42 am
by seisephiroth
the only difference I can see Is the SRT ones have ABS rings and the stockers dont, but then again i swapped to the SRT disks so i could be wrong
Posted: Mon Aug 27, 2007 3:19 pm
by deep1ca
If this topic is about swapping out the rear drums on a 00-02 neon to SRT-4 rear brakes....
....You will need the srt-4 rear knuckles & spindles...along with the calipers, rotors, pads, brake lines of course.
Posted: Mon Aug 27, 2007 5:32 pm
by Arro
No, I want to use the SRT hub with the drums. I know they're different because of the ABS rings but will it still fit? Are the non-SRT hubs shorter than the SRT ones?
Posted: Tue Sep 11, 2007 7:44 am
by daaboots
Hi. Just to clear some things up, you don't need the SRT-4 hubs and knuckles for the rear disc swap. I know this for a fact because I did the swap
http://forum.2gn.org/viewtopic.php?t=22281
As for the hubs being different, I'm with seisephiroth. I haven't actually done a side by side comparison, but I'm confident they are the same.
Posted: Tue Sep 11, 2007 12:30 pm
by Arro
I know I don't need them, but the knuckle increases the rear wheel base a bit more.