homemade strut bar

InfinityAudio · Post by **InfinityAudio** » Mon Feb 25, 2008 10:04 pm

I am a welder and I am wonderinf if anybody here had did some custom strut bar. If yes, is it really complicated.

I'll do steel strut bar if I do!

jckevns · Post by **jckevns** » Tue Feb 26, 2008 1:57 pm

Hudson_Neon makes them

Hudson_Neon · Post by **Hudson_Neon** » Tue Feb 26, 2008 10:47 pm

yep, i do. the angles are the hardest part. i've found that it's one of my gifts that i can just "see" everything and where it needs to be. the brackets that the bars are welded on to is kinda hard to make too.

fixitmattman · Post by **fixitmattman** » Tue Feb 26, 2008 10:53 pm

Last time I was working I had some brackets cut out for me when they ran the gauge of material I wanted on the laser table.

Those brackets are still sitting in the basement back home, still haven't made the bar yet