2GN.ORG

monday i will be going to pull off my newly acquired rear disc setup...........

what all do i need to swap this over??

tools

how about some intelligent replies please

use that massive intelligence of yours and go read the how to that is easily found in the how to forum (who woulda thought?)

its written up for SRT but the parts are basically all the same

http://forum.2gn.org/viewtopic.php?t=8325

Here is some info from my swap.

http://forum.2gn.org/viewtopic.php?t=22281

LaidNeon wrote:monday i will be going to pull off my newly acquired rear disc setup...........

what all do i need to swap this over??

rear hubs ........ brake parts.. that's about it...
and while you are back there install the rear control arm bushing kit if you don't already have it!!

spencersummerfield wrote:

LaidNeon wrote:monday i will be going to pull off my newly acquired rear disc setup...........

what all do i need to swap this over??

rear hubs ........

No No No... you dont need the hubs or the knuckles. You need the backing plate / dust cover, the calipers with the brake lines and pads, the ebrake cable, the ebrakes, and thats it!

daaboots wrote:No No No... you dont need the hubs or the knuckles. You need the backing plate / dust cover, the calipers with the brake lines and pads, the ebrake cable, the ebrakes, and thats it!

Some discs would help,too! j/k!