2GN.ORG

I adjust the hand brake, I also check if the cable were ok and the are, but the brake shoes are not working properly...they are not moving from the inside to the exterior they are moving from outside the car to inside th car.

It's kind of hard to translate in French. They are just moving exactly like if IU hade put them on somethind round so the y are not goind to brake but only ''pivotate'' on them self.

is anybody understand what I am trying to say.

what is the problem with this

Ainsi les câbles actionnent les leviers, mais les chaussures ne fonctionnent-elles pas correctement ? Avez-vous le disque ou le tambour ? de votre signature il s'avère que vous avez le disque. Je n'ai aucune expérience avec le disque. ainsi je can' ; aide de t vous beaucoup.

I used bable fish to translate, so if it make no sense, I apologize.

So the cables are operating the levers, but the shoes are not working correctly? Do you have disk or drum? from your signature it appears that you have disk. I have no experience with disk. so I can't help you much.

http://babelfish.yahoo.com/translate_txt

actually went able to understand...and yes I have rear disc comming from a 99 r/t

Pictures? I think maybe I understand, except for the pivot part. There is thread to adjust brake. viewtopic.php?t=37023&highlight=ebrake

Also use search for "ebrake."

Also look in "HOW TO" section.

I adjust it but even when it's adjust to the maximum, whan I pulled the ebrak it didn't work the shoes are not moving in the right direction.

Is there any way to have them installed on the wrong sides? Like the left assembly on the right side and vise versa.

well I could check this but I will check that as soon as I can

I own a 2002 with 4 wheel disc/abs brakes.The brakes only have a piston on the inboard side and they slide together to clamp the brake disc.My suggestion to you is make sure the surfaces that the caliper slides on is clean and use some molybdenum spray on the slides to make sure that everything moves freely.

Mike