Location: Cape May County, NJ (1 hour south of Atlantic City)
Contact info: Send me a PM and I will reply with my phone number and email
Feedback: Feedback on here!
Hey, Guys! It's time to sell my neon as I've waited long enough after getting my truck.
She's a 2003 Dodge neon SXT ATX with 113,xxx miles on the body as the engine and trans were replaced at 69.xxx mi along with the water pump, tensioner, and timing belt. She's not perfect but for being 10 years old she's in pretty good shape! aside from a few dings and a run in with a raccoon that took off my front lip she's still a pretty clean car! I'm asking 2,500.
Mods:
Suspention:
Kazera lowering springs 1.4" front 1.5" Rear
Ebay front strut bar
DC sport rear strut bar
Tie rods replaced with Moog greaseable ends
New front disk with less than 1 set of pads wear
Engine:
Replaced engine and trans at 69,xxx mi
AEM CAI with wet filter
60mm TB (forget the brand)
Granatelli coil and plug wires
Interior
Cloth R/T Seats front and rear
Blue LED accent lights
Sony Xplod head unit (AM/FM/CD/AUX/USB with Ipod control)
Sony Xplod rear 6x9s
Exterior
Mopar lip (rear and sides) in black
Black rear spoiler
unpainted (silver) FG vented hood
Black housing headlights
Black grill trim
Tinted tails and center brake light
black side markers
Projector fogs
Parts I have but are not installed and other stuff coming with the car
Volt gauge in SRT gauge pod
R/T head mostly stripped down ready for some TLC/custom work before putting on the car
Slightly rusty 03 R/T cam
Stock Head unit
Jack Stands
Stock Exhaust Axel back
R/T Exhaust Axel back (reducer rusted though, haven't stretched the mid pipe to match the fit yet)
cracked r/t intake manifold. (Cyl 4 runner near head is cracked at mating surface)
Prothane front LCA bushings.
The Bad
Alt. belt could use a tightening
Front LCA bushings are bad, haven't replaced them but have the replacement bushings
Several small dings and dents, nothing major, just tiny things
front bumper has holes and a crack repaired with zipties on the underside of the passenger side where the mopar front lip was, raccoon strike took it out.
CPS is bad, throws code P0340 Can fix before sale
No axle back, will put the stock one on, will include r/t exhaust in sale.
Pictures
AEM CAI

Intake installed and TB

Upper front view as she sits now

View of hood from inside the car

Black grill trim

Head unit at night

New rotors and outer tie rod ends when installed

Hood with old headlights

Again, the asking price is 2,500. Thanks for looking