2GN.ORG

I'm trying to remove the foglights on this '00 SE, so I can install some brake ducts. But After spending a few minutes under the front end, I can't see how to remove them. Can someone give me some help with this? Thanks.

*bump*

Nobody knows how?

I didnt have fogs on my 00 front....
Take off the bumper it takes like 10 seconds and then take a good look on how to remove the fogs


OR just buy a haynes manual

you dont have to take off the bumper, but it is a bit of a pain... the passenger side not so bad, undo a couple bolts holding the airdam and drop that to get some arm room, i used a small 1/4inch rachet w/ a really short socket.. cant remember the size.. you can feel behind there there is 2 bolts holding the foglight housing in. undo that, and the come right out..

the drivers side is a PAIN if you have the stock airbox intake setup, that box in the fenderwell is in the way, you WILL HAVE TO remove that to get to the drivers side fog light bolts... good luck...

10 mm wrench. To take them off on my R/T, I took out the headlights (8mm I think) and then you get a clear shot down at the 3 bolts holding them in on each side. I have an intake so drivers side wasn't an issue.

Mine were a pain to pop out after I got the nuts off, because they still were stuck. (holes were tight) I ended up tapping them out lightly with a small hammer. Although the fog lamps are slightly different, they go in and come out and use exactly the same holes.

I broke both sets of the ones I had in both the RT and SXT bumper. One bolt never wants to come out. Good luck!