fog lights

bstc00 · Post by **bstc00** » Fri Oct 26, 2007 6:57 am

So i have this problem with my fog lights. they just stopped working on me, both of them. any ideas?

evilneon02 · Post by **evilneon02** » Fri Oct 26, 2007 7:04 am

ok it could be the bulbs are bad a short in the wire or the connection behind the lights or the switch in the car when bad.

NiteHawk · Post by **NiteHawk** » Fri Oct 26, 2007 7:33 am

check all connections, check the fuse, etc...if you dont find anything, try replacing the bulbs...if that doesnt do it...find someone with a multimeter and start testing wires and find your problem...

Adionik · Post by **Adionik** » Fri Oct 26, 2007 11:30 pm

How big are stock 03+ fog lights?

Please say 2 1/2 because I bought fog lights from Walmart and they better fit...

Kelevra · Post by **Kelevra** » Sat Oct 27, 2007 1:29 am

Adionik wrote:How big are stock 03+ fog lights?

Please say 2 1/2 because I bought fog lights from Walmart and they better fit...

try 4-4.5" just measured in the dark.

Adionik · Post by **Adionik** » Sat Oct 27, 2007 1:31 am

are you serious....that's freaking huge.

Damnit!

Kelevra · Post by **Kelevra** » Sat Oct 27, 2007 1:39 am

Adionik wrote:are you serious....that's freaking huge.

Damnit!

yeah, i measured from the inside of the hole to the oppisite side, the lights fit in there snugly so yeah. let me double check fo you...

4 Inches almost exactly for the light

Adionik · Post by **Adionik** » Sat Oct 27, 2007 1:42 am

Well, I have an SRT bumper...let's see how these fogs fit. I wonder if they're even worth taking off my deletes for. I have my deletes on with some pretty good glue. Damnittt....

thanks kalvera

Kelevra · Post by **Kelevra** » Sat Oct 27, 2007 1:45 am

Adionik wrote:Well, I have an SRT bumper...let's see how these fogs fit. I wonder if they're even worth taking off my deletes for. I have my deletes on with some pretty good glue. Damnittt....

thanks kalvera

no problem. I think the SRT and the SXT fogs are the same :/ good luck with that BTW use silicon next time, sticks good but comes off easy when needed

Adionik · Post by **Adionik** » Sat Oct 27, 2007 1:53 am

I didn't use silicone, but very similar. It's like black silicone...very stick, very messy and very hard to take off. I'll probably use 3m tape if I decide to not go with the fogs....

Kelevra · Post by **Kelevra** » Sat Oct 27, 2007 1:59 am

Adionik wrote:I didn't use silicone, but very similar. It's like black silicone...very stick, very messy and very hard to take off. I'll probably use 3m tape if I decide to not go with the fogs....

I used clear silicon too put on my FG eyelids

it will take some work to get them off because I used ALOT. lol, but it ill be awhile till i get close to getting new headlights. so yeah

Adionik · Post by **Adionik** » Mon Oct 29, 2007 12:18 am

Are there any way to "aim" fogs? Because I tried a bit...couldn't really get them to do it that well. They're still pretty high up. Damn they are SUPER bright bulbs...I hope I don't get a ticket!

NiteHawk · Post by **NiteHawk** » Mon Oct 29, 2007 12:35 am

aye....pretty much as headlights...measure distance from ground to the center of the foglight, go out 25ft, mark a line, aim foglights just below that mark...

always wanna keep lights parallel to the ground, or slightly down

Adionik · Post by **Adionik** » Mon Oct 29, 2007 1:37 am

This was a universal kit, so i'm going to have to find a better mounting system than zip ties. HAH.

Where the hell is the firewall? I need to run the relay wires through there...cant' seem to find it.

NiteHawk · Post by **NiteHawk** » Mon Oct 29, 2007 1:45 am

please tell me you're joking......

its the big peice of metal that seperates the cabin from the engine bay.........its where the brake booster is mounted...............

Adionik · Post by **Adionik** » Mon Oct 29, 2007 1:54 am

I know where it is, i'm just looking for that opening to run it through...

BTW does anyone know anything about how the SRT surrounds work? My fog lights are pretty much the same size as stock SRT/SXT fogs, so i'm pretty sure they'll work. Other than tinting them, I want to get the surrounds...think they'll fit?

NiteHawk · Post by **NiteHawk** » Mon Oct 29, 2007 3:26 am

how they work?

the covers just snap in place...