what skirts and rear bumper?

lewis1015 · Post by **lewis1015** » Sun Jun 01, 2008 6:39 pm

hey i have a 04 sxt with a srt-4 bumper and a srt-4 carbon fiber hood. i plan on lowering it 1.5 inches and getting some new rims. and after that i want to get side skirts and a new rear bumper.
what do you think i should get, srt skirts and rear bumper?
or mopar lip kit skirts and rear bumper?
im leaning more towards the mopar because i want something kindof original and i dont want to completly copy the srt-4. (i did the front bumper cuz i hate the 03-05 bumpers and love the srts, also plan on swapping srt engine a while down the road)
let me know what you think. thanks!

pic of my car:

pics of mopar skirts and rear bumper: (i think this is someone on this forums car, hope you dont mind me using it, only pic i could find.)

Srt-4 skirts and rear bumper:

bombtrack07 · Post by **bombtrack07** » Mon Jun 02, 2008 1:38 pm

only the SRT skirts and rear bumper will look right with the SRT front bumper.

DouglasSXT · Post by **DouglasSXT** » Mon Jun 02, 2008 5:05 pm

I like the mopar sides as well... Will look real nice with the drop and some nice rims!

lewis1015 · Post by **lewis1015** » Mon Jun 02, 2008 9:06 pm

what about srt skirts, and mopar rear bumper?

lewis1015 · Post by **lewis1015** » Wed Jun 04, 2008 8:32 pm

bombtrack07 · Post by **bombtrack07** » Thu Jun 05, 2008 12:51 pm

If you plan on getting the SRT exhaust, it won't fit right on the Mopar rear bumper. something about the cutouts being too small or not lined up with the tips IIRC.

lewis1015 · Post by **lewis1015** » Thu Jun 05, 2008 12:58 pm

this is probaly a dumb question, but if i do a 2.4 srt swap will i need the srt exhaust?

welchspro · Post by **welchspro** » Thu Jun 05, 2008 1:21 pm

you won't specifically need the srt exhaust, but you'll want to run an exhaust of similar size. however the exhaust gas exits the car is entirely your choice. (side exit, single tip, fart cannon, dual, quad, stinger, you get the point.)

lewis1015 · Post by **lewis1015** » Thu Jun 05, 2008 1:31 pm

ok cuz i have a magnaflow dual catback system now, would that work?

bombtrack07 · Post by **bombtrack07** » Thu Jun 05, 2008 3:07 pm

it will work as long as it's 2.25". if you do the SRT swap, I would go with no less than 2.5" exhaust pipes but the perfect size is 3" at least cat-back, if not turbo-back. the exhaust is a bottleneck for our engines.

LilSparkPlug · Post by **LilSparkPlug** » Thu Jun 05, 2008 4:27 pm

That silver car is supertrick05's SXT. I think you should just go all out and do the whole SRT kit. Even though you aren't an SRT (yet) it will flow the best out of everything you have listed there.