lip kit 3m tape question

Fuzzyneon · Post by **Fuzzyneon** » Fri Jun 27, 2008 1:55 am

i installed my front and rear lip and now theres like a 1mm gap in some of the sports where the tape didn't stick if i wash my car or get this wet will it undo the rest? and is there a easy way to fix this (you cant even tell unless you get real close and look) i just wanna make sure by washing it it wont get worst.

Wenuden · Post by **Wenuden** » Fri Jun 27, 2008 1:59 am

take a heat gun to it a small section at a time and then lean into it for a few minutes while the glue cools and resets. If that doesn't work, you'll probably have to remove it and retape it.

Fuzzyneon · Post by **Fuzzyneon** » Fri Jun 27, 2008 2:00 am

Wenuden wrote:take a heat gun to it a small section at a time and then lean into it for a few minutes while the glue cools and resets. If that doesn't work, you'll probably have to remove it and retape it.

so you think its all gonna detatch itself? im not worried about the small gap just it undoing itself

DoubtedNeon · Post by **DoubtedNeon** » Fri Jun 27, 2008 8:12 pm

ide just do it the right way and re tape it all...its better than it comming off or something on the road...

Fuzzyneon · Post by **Fuzzyneon** » Fri Jun 27, 2008 10:17 pm

DoubtedNeon wrote:ide just do it the right way and re tape it all...its better than it coming off or something on the road...

i actually looked again today and "the gap" i thought was there was just the part where the tape is its not actually incorrect

theTeejmiester · Post by **theTeejmiester** » Sat Jun 28, 2008 2:47 am

^^^ that is a very hard sentence to read

jetas · Post by **jetas** » Sat Jun 28, 2008 10:59 am

I cant make sense of that sentence

Fuzzyneon · Post by **Fuzzyneon** » Sat Jun 28, 2008 12:21 pm

Basically there wasn't a gap im just paranoid lol