Page 1 of 1
3m tape and r/t side skirts
Posted: Sun Apr 19, 2009 10:56 pm
by fearingdark
i did the search thing and found out that i can use 3M stickty tape to install the r/t skirts. only thing is, i'm not sure where to put the tape...
should it go on the part that would normally tuck into the hookstrip? or on the very top where it meets the car?
i'll still be screwing them in on the bottom.
Posted: Mon Apr 20, 2009 7:16 am
by Passt
Put it in both places to ensure adhesion.
Posted: Mon Apr 20, 2009 8:59 am
by lilnicko11
Passt wrote:Put it in both places to ensure adhesion.
+2
Posted: Mon Apr 20, 2009 1:34 pm
by fearingdark
cool...thanks
Posted: Mon Apr 20, 2009 4:08 pm
by InfinityAudio
I will put metal screw through the side skirt by under the car my double tape try never worked.
Posted: Mon Apr 20, 2009 4:52 pm
by fearingdark
wll, i'm going to do the screws on either end and underneath
Posted: Mon Apr 20, 2009 11:21 pm
by 03blackrt
When I put some Mopar skirts on my '03 I put a thin (~ 1/8" thick) strip of the 3M double-sided tape on the top rail thingy and it wouldn't even touch the car to stick. I doubled it up (about 1/4" thick) and it stuck but started sagging in a few days. Then I finally ran one strip (~ 1/8" thick) across the very upper protion of the skirt and it finally stuck on there for good and made a nice tight seal between the body and skirt. I also ran a strip across the bottom and put the two screws in either end.