Mount H.I.Ds
Posted: Fri Mar 12, 2010 3:07 pm
Where can i mount my hids without having to drill any hole??
Page 1 of 1
Posted: Fri Mar 12, 2010 3:13 pm
I recommend you secure the ballast (drill one hole for each that should keep them in place.)
Posted: Fri Mar 12, 2010 5:42 pm
I bent the ballast holder and screw them under the two screws in the fender. It won't move in that case.
Posted: Fri Mar 12, 2010 8:34 pm
Double sided tape them to the inside of the frame apron (underneath the fender) in the engine bay.
Posted: Fri Mar 12, 2010 11:17 pm
^but will the temperature be high enough to melt or damage the tape?
Posted: Sat Mar 13, 2010 2:41 pm
My ballasts have been in this location since 2005 without issues. My foglight ballasts have been in their respective locations since 2007 without issues.
Foglights (bolted and double sided tape):
Passenger side:
Driver side:
Headlights: Double sided tape only:
Passenger side:
Driver's side:
Those are shots from 07...lol bear with me
Foglights (bolted and double sided tape):
Passenger side:
Driver side:
Headlights: Double sided tape only:
Passenger side:
Driver's side:
Those are shots from 07...lol bear with me
Posted: Sun Mar 14, 2010 2:22 pm
I actually had mine come off quite frequently with 3m double sided outdoor tape. They were in a warmer area though.
Posted: Sun Mar 14, 2010 2:29 pm
Yeah I never had an issue up here in little Rhody. I used the Red-back.
Posted: Sun Mar 14, 2010 3:37 pm
I guess I meant a warmer area of the engine bay lol.
Posted: Mon Mar 15, 2010 7:55 am
don't stick it to the exhaust with doublesided tape... 
Posted: Mon Mar 15, 2010 8:13 am
I have them in the same place but I used a nut and bolt with a hole that goes through the fender wall that's there from factory. Bolt fit perfect the only way I was able to access the nut was to remove the headlight and I could get a wrench in there as I tightened the bolt. I'll have to get pics of it but it's in the same place as "Lilsparkplug"'s.