Page 2 of 2
Posted: Fri Jul 29, 2011 3:12 pm
by DetergentCandy
nerox wrote:Are you still looking for the measurements for the hammerhead?
i've got a factory fit one on my R/T and dont mind taking some measurements or making a template if you need it ?
That would be very much appreciated!
PM'd.
Posted: Fri Jul 29, 2011 4:33 pm
by nerox
i'll get that done this weekend and get some photographs up for y'all
Posted: Sat Jul 30, 2011 9:37 am
by sidepipe87
Sorry detergent. I got your PM but was at work. If nerox can't do it, I can but it might be a while since the trunk itself is at my grandma's house right now.
Posted: Sat Jul 30, 2011 3:24 pm
by DetergentCandy
sidepipe87 wrote:Sorry detergent. I got your PM but was at work. If nerox can't do it, I can but it might be a while since the trunk itself is at my grandma's house right now.
No problem!
I'll keep you updated
Posted: Mon Aug 01, 2011 5:08 pm
by nerox
Well i haven't really had a chance to make up a template as such but had half hour free this evening so i took some photos to ease the curiosity.
LHS screw hole
RHS screw hole
Both
Inside bolt hole locations
Upper
Lower
Same as the LHS
All 4 locations
Spoiler part number
Made in Canada
Re-Assembled
Posted: Mon Aug 01, 2011 6:04 pm
by DetergentCandy
Those are awesome! From the underside, they're in completely a different location than I thought they would be
I was close...but not close
Think you'll still be able to get a template put together at some point?
Posted: Tue Aug 02, 2011 1:27 am
by nerox
Sure
Posted: Tue Aug 02, 2011 2:05 am
by DetergentCandy
nerox wrote:Sure
Can't wait!
