Page 1 of 1
fender liners from scratch?
Posted: Fri Jan 27, 2006 1:17 am
by Praesepe559
Im looking for some sort of material I can use to make fender liners that will actually match up with the body kit and be a little smoother. I have taken one of my liners into like 5 stores, a body shop, upholstry shop.. and nobody can think of where i can pick up a similar material to work with, any ideas???
Posted: Fri Jan 27, 2006 1:51 am
by Casketbearer
someone on here used cheap rubber floor mats cut to fit.
Posted: Fri Jan 27, 2006 10:37 am
by joelrgr
Ive seen ppl use diamond-plate. Like the stuff they make tool boxes for trucks and some floor mats with. It was a little flashy but they had it chromed and it worked nicely on a slammed show car.
Posted: Fri Jan 27, 2006 2:23 pm
by Praesepe559
hmm.. not going for that flashy of a look lol. What i want is pretty much whatever the stock ones are made out of.. but if i cant get a hold of that i would lean more toward a plastic material than a rubber one. still stumped on this one..
Posted: Fri Jan 27, 2006 5:02 pm
by dawm
try going to a vinyl shop/sign shop. they might have some heavy duty material you could use
Posted: Sat Jan 28, 2006 12:45 am
by joelrgr
^ good idea!
Posted: Tue Jan 31, 2006 4:18 am
by juicyjay504
try somewhere like Lowes