Clear Corners Installed

J8t4m · Post by **J8t4m** » Mon Feb 06, 2006 3:46 pm

This is more of a informative post . . . .

I got my clear side bumper housing installed

I ended up having a fitment problem

the notches in the housing werent quit big enough to let the Rubber light socket fit and twist in

Heres what I had to do: I ended up have to take a pocket knife and shave alittle plastic out of the inside of the clear housing to allow the notches on the rubber socket to slide down - Im sure a small file would work out better than a knife . . . but thats all I had . . .

Just wanted to post this for anyone else that might have a slight fitment problem (*thats what i get for shopping ebay*)

Mopar00Neon · Post by **Mopar00Neon** » Mon Feb 06, 2006 6:07 pm

Ebay or not, the lights are all the same no matter where you get them from. I got another set from Modern and had the same exact problem. I used a small file to trim the little tabs down though.

03sxt · Post by **03sxt** » Mon Feb 06, 2006 6:35 pm

I just kinda' forced mine in.

No problems.

Or you could do it the gross cheesy porn way and spit on it then push it in.

cgneon · Post by **cgneon** » Mon Feb 06, 2006 9:17 pm

same with mine from modern.. drivers side fit fine, passenger side had to cut it to make it fit..

joelrgr · Post by **joelrgr** » Tue Feb 07, 2006 12:03 am

Utility knifed mine lol also from modern

scneonchic · Post by **scneonchic** » Tue Feb 07, 2006 12:06 am

I had some like 3 years ago, they were APC

but thats all I could find at the time, and they worked just fine, no trimming needed