New to 2GN, not new to Neons or Cars. (56K Beware)
Posted: Thu Apr 09, 2009 12:19 am
Hey everyone just wanted to say hey, my name is Chris. I have been into the car thing since I was in high school, I had a garage and tools, so learned how to work on my car to save money.
I started with a 1989 Chevy Cavalier, it was cheap and I shared it with my mom, I know I am not alone there. Well a few years later, my mom got a better job and bought a new car. So I had this cavalier and a minimum wage salary, so I start working on it to make it a bit nicer.
Well after a few years I turned it into my first show car. I won some awards at J-boy shows and few small shows in the area.
I was also the VP of my area of for the JCO (J-body Club of Ontario).











My next car was a base 4 door 95 Dodge Neon, it had less then 100,000km on it. The plan was to go all power and no show stuff, I was sick of the show car scene. The car made 224.2whp 227.8wtq @ 12psi on 94 octane pump gas and a 100% stock long block. I have also included a list of my setup below.
My setup:
- 1995 SOHC 4 Door Neon
- AC & PS removed
- 250lbs in weight re-ducts
- Canton Oil pan w/ windage tray
- Mattdog SOHC to SRT-4 head Adapter plate
- Stock SRT-4 turbo and mani
- Stock SRT-4 O2 housing
- Stock SRT-4 down pipe
- Dynomax 2.5" Mandrel Bent cat back w/dynomax muffler
- 2.25" IC Pipes
- 2.25" CIA w/ KN&N filter
- Stock SRT-4 intercooler
- 1st gen DSM BOV
- Kinetic Motorsport manual boost controller
- Fast Fabs magnum runner intake manifold
- 57mm TB
- Unorthodox UDP
- Lorenzo Billet Fuel Rail
- Aaron Neon Return line kit (Aeromotive 1:1 FPR)
- Acell #36 injectors
- D-Tech FC
- AEM UEGO
- Auto-Meter Phantom 20 psi Boost Gauge
- NGK Plugs - stock gap
- Swapped from ATX to MTX
- Clutch Masters Stage 4 6 puck non-mod clutch
- Mopar performance plug wires
- RT SDE front and rear struts
- Mopar High Rate springs
- Energy Suspension full bushing kit
- Stock front and rear sway bars
- front strut tower brace
- Small tractor battery
- Deyeme Racing Side, Tranny, Front Motor Mounts,
- Deyeme Racing Front Air Dam and Rad Brackets
- Vitor Solid Bobble strut
- Booger shifter bushings
- Greddy Catch Can
- Moroso Coolant overflow
- PT Performance coil pack heat shield
- PT Performance check valve
- Vitor EGR Block off kit













Well I moved to a new place with no shop and had no where to put my green car so I parted it out and kept my 2003 SX (winter car).
This car is a base model SOHC 5spd. The car has 50,700KM on it and is in great condition. I have a 1st gen Dynomax muffler, tinted windows, Mopar plug wires, and NGK Plugs as my only mods right now. However I have a closet full of parts to put on this summer. I will post pics as I get some stuff done.
Here are a couple of pics I snapped tonight quickly. It needs a wash, which it is getting this weekend; we had snow here this week.



I also used to part out 1st gens and sell the parts on neons.org and neon Canada, I have listed my neons.org feedback and my Neon Canada feedback (+21) can be seen under the same user name. I also have some feedback on the SRT Forums, same user name as well.
Feedback
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
I started with a 1989 Chevy Cavalier, it was cheap and I shared it with my mom, I know I am not alone there. Well a few years later, my mom got a better job and bought a new car. So I had this cavalier and a minimum wage salary, so I start working on it to make it a bit nicer.
Well after a few years I turned it into my first show car. I won some awards at J-boy shows and few small shows in the area.
I was also the VP of my area of for the JCO (J-body Club of Ontario).











My next car was a base 4 door 95 Dodge Neon, it had less then 100,000km on it. The plan was to go all power and no show stuff, I was sick of the show car scene. The car made 224.2whp 227.8wtq @ 12psi on 94 octane pump gas and a 100% stock long block. I have also included a list of my setup below.
My setup:
- 1995 SOHC 4 Door Neon
- AC & PS removed
- 250lbs in weight re-ducts
- Canton Oil pan w/ windage tray
- Mattdog SOHC to SRT-4 head Adapter plate
- Stock SRT-4 turbo and mani
- Stock SRT-4 O2 housing
- Stock SRT-4 down pipe
- Dynomax 2.5" Mandrel Bent cat back w/dynomax muffler
- 2.25" IC Pipes
- 2.25" CIA w/ KN&N filter
- Stock SRT-4 intercooler
- 1st gen DSM BOV
- Kinetic Motorsport manual boost controller
- Fast Fabs magnum runner intake manifold
- 57mm TB
- Unorthodox UDP
- Lorenzo Billet Fuel Rail
- Aaron Neon Return line kit (Aeromotive 1:1 FPR)
- Acell #36 injectors
- D-Tech FC
- AEM UEGO
- Auto-Meter Phantom 20 psi Boost Gauge
- NGK Plugs - stock gap
- Swapped from ATX to MTX
- Clutch Masters Stage 4 6 puck non-mod clutch
- Mopar performance plug wires
- RT SDE front and rear struts
- Mopar High Rate springs
- Energy Suspension full bushing kit
- Stock front and rear sway bars
- front strut tower brace
- Small tractor battery
- Deyeme Racing Side, Tranny, Front Motor Mounts,
- Deyeme Racing Front Air Dam and Rad Brackets
- Vitor Solid Bobble strut
- Booger shifter bushings
- Greddy Catch Can
- Moroso Coolant overflow
- PT Performance coil pack heat shield
- PT Performance check valve
- Vitor EGR Block off kit













Well I moved to a new place with no shop and had no where to put my green car so I parted it out and kept my 2003 SX (winter car).
This car is a base model SOHC 5spd. The car has 50,700KM on it and is in great condition. I have a 1st gen Dynomax muffler, tinted windows, Mopar plug wires, and NGK Plugs as my only mods right now. However I have a closet full of parts to put on this summer. I will post pics as I get some stuff done.
Here are a couple of pics I snapped tonight quickly. It needs a wash, which it is getting this weekend; we had snow here this week.



I also used to part out 1st gens and sell the parts on neons.org and neon Canada, I have listed my neons.org feedback and my Neon Canada feedback (+21) can be seen under the same user name. I also have some feedback on the SRT Forums, same user name as well.
Feedback
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon
http://forums.neons.org/viewtopic.php?t ... ht=raekwon