A few questions

Doing a SRT-4 Motor swap into your Neon, maybe even a 2.4... have questions about it, what you'll need or what issues you'll run into? Answers can be found in here.
Post Reply
shinta86
2GN Member
Posts: 107
Joined: Sun Apr 29, 2007 9:27 am

A few questions

Post by shinta86 » Sat Jul 12, 2008 1:09 pm

If the end of the pass axle came off is it still resusable?
Image

What stage PCM is this? Stage 0?
Image

This is at the end of an 04 bay harness where it plugs into the AC block on the firewall. What is supposed to be at the end of the green/red and black wires? Does my 01 bay harness have the connector?
Image

Thanks in advance
Top
occasional demons
Junior Admin
Posts: 20067
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sun Jul 20, 2008 11:32 am

For the half shaft, if you have all the parts and it is clean, you should be able to reassemble it with fresh lube and it should be fine. That is if it just slid apart. I haven't had one apart in years, so I don't know if these have any retaining clips or not. I would wait till someone confirms this.
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Top
User avatar
Nutmeg
2GN Member
Posts: 1524
Joined: Wed May 16, 2007 7:14 pm
Location: Washington

Post by Nutmeg » Sun Jul 20, 2008 12:13 pm

The axle had a ring around it that was holding it together, that was probably broken.
Image
Top
User avatar
blue demon02
2GN Member
Posts: 1212
Joined: Sun Aug 07, 2005 11:32 pm
Location: San Antonio, TX 78148
Contact:
Contact blue demon02

Post by blue demon02 » Sun Jul 20, 2008 2:23 pm

Nutmeg wrote:The axle had a ring around it that was holding it together, that was probably broken.
Yup but you can get new ones for way cheap. I can't see the pics at the moment but if te knuckles still look good with no pitting or rubbing on them then re-lube it put it back togeather and slap on the new strap.
Image
Top
Post Reply

Return to “Motor Swap”