start problems

cody87csx · Post by **cody87csx** » Tue Nov 18, 2008 4:02 am

i finished my swap and went to turn the car over i get nothing. checked the wires for the clutch switches and im all good there. then i noticed the fuelpump wasnt turning on. i know now its something to do with my asd relay not functioning. will the asd relay not working cause the car not to crank? i know my ecu skim and key are good the worked just fine in a buddys car. so were do i start next

hansken_yo · Post by **hansken_yo** » Tue Nov 18, 2008 10:42 am

We need some more info...

If its a wiring issue we'll need to know if it is an 00-02 swap, 1gn swap or 03-05 swap or something else. Also know exactly what was swapped would be a bonus (I'm assuming SRT-4, but its always good to check).

cody87csx · Post by **cody87csx** » Tue Nov 18, 2008 1:04 pm

oh yeah sorry its a complete srt swap into a 2000. dash, all wiring from front to back.

cody87csx · Post by **cody87csx** » Thu Nov 20, 2008 12:12 am

anyone help? if the asd relay isnt working properly will that cause the car not to turn over

Post by **occasional demons** » Thu Nov 20, 2008 12:28 am

Have you jumpered the starter solenoid to check that the starter will crank, just to verify it works? I am not 100% sure the ASD will shut down the starter relay. If you have access to a wiring diagram, jumper the asd pins that the contacts close, and see if it cranks/runs fuel pump, etc. if all works, then the ASD relay is either not getting it's signal, or it doesn't work. It still prolly wouldn't fire if it is a skim problem tho. IIRC the SKIM also shuts down the coil and injector drivers. Otherwise it could be easily bypassed by what I just suggested.

Edit: if you check the sticky right above here, you will find enough info to research the wiring, if you poke around enough.

viewtopic.php?t=29536

cody87csx · Post by **cody87csx** » Fri Nov 21, 2008 12:16 am

i did jump the relay and it does crank so i will trace the wires for the asd relay