hey, i was looking at buying some used bride seats and the guys saying just use your stock brackets and weld them...can anyone elaborate on this...
pics?
i dont know what to do and i dont wanna mess up my brackets in case i wanna go stock again.
Brackets
-
Fuzzyneon
- 2009 Silver Contributor
- Posts: 4872
- Joined: Fri Oct 26, 2007 12:48 am
- Location: Waterford works ,NJ
Re: Brackets
Im not 100% but im assuming if you weld them they wont be able to be oem again see if you can find brackets for those seats on ebay and swap the bracketsflhmfd wrote:hey, i was looking at buying some used bride seats and the guys saying just use your stock brackets and weld them...can anyone elaborate on this...
pics?
i dont know what to do and i dont wanna mess up my brackets in case i wanna go stock again.
Member of Spork Racing
2002 Dodge Neon
Frankenstien
2002 Dodge Neon
Frankenstien
-
Mr Josh Zombie
- 2010 Platinum Contributor
- Posts: 8357
- Joined: Tue Aug 22, 2006 8:43 pm
- Location: Toledo, OH
-
randomZERO
- 2GN Member
- Posts: 873
- Joined: Sun Dec 02, 2007 3:34 am
- Location: Baltimore
You have to chop up the stock bracket then weld 2 steel strips to the stock bracket where the bottoms would bolt (if they are bottom bolting) Sparcos and Brides are a side mounting seat so im not sure about those but prolly easier and cheaper to get the aftermarket ones. I have a Corbeau seat and am using a stock bracket that I modded.
