2GN.ORG

heres some pics of my new cobra seats with sparco harnesess and my shift ligth

AWESOME! And RHD too. Bring that to the states and you will have guys drooling over it wherever you go.

Wait... one of your gagues is off...

ha ha thanks

That is awesome! And I like the RHD too, very cool.

Where do you get these seats to fit the brackets? I wouldn't mind getting racing seats/harnesses, but I don't know where to look to get brackets that'll work without any crazy fabrication..

Sweet dude love it. How did you go about wiring that shift light? I wanna get one my SRT.

Am I seeing this shit right?!

You're driving on the wrong side...lulz

ha ha lol am from england so driving on the other side.

i had to custom make the brakets for the seats by striping the old ones down and then weldin two 5mm steel bars across were the seats sit been a bit slimmer.

driver seat were tricky with it use to having a motter.

as for the shift light one wire to a live feed (gauge cluster) one wire to the earth and then the hard bit one wire into the engine bay on to the wires running of the coil pack.

i used the wire closser to the front of the car dont use the middle wire with it been a + i have heard you can use the back wire as well

hope this helps guys

Fuuuuck I want RHD.

Looks Awesome i love those seats........I want some.

Nice setup. Did you swap your dash guages? I'm surprised that the Km/h numbers on the speedo aren't the larger of the two (as opposed to MPH).

we work in mph over here there just the factory ones for the time been going to do the lights red soon tho

RHD ftw and the seats look very sharp