Page 1 of 1
Shifter Bezel thing
Posted: Fri Sep 24, 2010 12:40 am
by Trappy
Alright, I don't know what it's called, but it's that piece that goes around the bottom of the shifter on an automatic tranny. I found an 03-05 SXT with carbon fiber look one. Got the HVAC bezel out just fine, but the one around the shifter won't budge. Please help!
Thanks!
P.S. What IS it called?
Posted: Fri Sep 24, 2010 1:37 am
by zhneon
It's called the shifter bezel for one, and I can't remember exactly what it takes to get it out...
You definitely need to remove your center console, which has screws in the cup holders and the bottom of the storage compartment. Pull the parking brake as far up as possible and pull up and back on the console to remove it.
You also need to remove one screw to remove the shift knob, it is located in the front of the knob and is some sort of torx bit if I remember correctly. Other than that, I think there are four screws at the base of the bezel, and you pop the bulb out, and it should be out. Hope that answers your question.
Posted: Fri Sep 24, 2010 1:44 am
by Trappy
Alright, thanks! If I need to do all that to take the bezel out of the SXT, I'll do it and put it in my SE. If I have to put in a whole new center console, then I won't bother with it...
Posted: Fri Sep 24, 2010 1:55 am
by zhneon
You don't have to change the whole console, you just have to remove the center console to get it out. The bezel is actually more than just the oval shape, there is more underneath that can't be pulled through, which is where the other screws are. The console is just the whole plastic divider between the driver and passenger seats, which is the same in all 2gn neons
Posted: Fri Sep 24, 2010 8:12 am
by Trappy
Okay, thanks! I'll just have to look out for the broken glass in the donor car...
Posted: Sat Sep 25, 2010 12:58 pm
by Trappy
Okay, there were 2 engines through the roof of the donor car today. No bezel for me
Posted: Sat Sep 25, 2010 1:52 pm
by sidepipe87
remove the console, unbolt the shifter bezel, unscrew the Torx set screw on the front of the knob and take the assembly out. At least I assume this is how it would be done...
Posted: Sat Sep 25, 2010 8:45 pm
by occasional demons
Trappy wrote:Okay, there were 2 engines through the roof of the donor car today. No bezel for me
Catapulting engines in the JY FTW!
Hitting neons FTL!
Bastids.
Posted: Sat Sep 25, 2010 11:35 pm
by Trappy
For real! 1 Neon 3 engines. It's powered by Dodge, Honda, AND Ford!
