2GN.ORG

i did some photoshoping!

before

no wing,no sponser's,no roof scoop

bagged,shaved!

I like it bagged and shaved.

I'd also black out the grill and throw some black tint instead of the yellow.

and remove the side moldings too

i kinda like the yellow tint it flows with the car.

bagged...it's the bestest (grammer ftw)

you know, i'm trying to like it, but i just can't dig it. i love the interior. but that's about it. but then again it's your ride not mine. so rock on with it man.

graf AXEL wrote: and remove the side moldings too

Agreed. With the side skirts and the wide body the side moldings really have to go. It's too busy with them.

Here ya go. No side moldings, tinted windows, black rims, and black mesh.

Opi wrote:Here ya go. No side moldings, tinted windows, black rims, and black mesh.

hey opi you can do that to your car your almost there anyways.......

I know!

Just need a new tinted window, powder coat my rims, and find a couple grand lying around to get my body kit put on and painted.

Opi wrote:Here ya go. No side moldings, tinted windows, black rims, and black mesh.

FTMFW.

i like it with the tint and rims but grill will stay the same! question on that side molding-is it just on there with double sticky tape?

sure is. shouldn't take ya more than 30 minutes total to remove em and clean up anything left behind.

i would STRONGLY suggest being VERY careful on your car.

since it has been repainted (doesnt look stock yellow to me) you better peel up just a little bit of it and make sure the original color isnt underneath, otherwise it will look really bad. i hope thats not the case, becasue no sidemoldings would look KILLER on your car.

i like the shopped pic...make it happen

the yellow with black wheels is the fucking hottness!!!!!!........i dont like it bagged and shaved though ...........1

TNK wrote:i would STRONGLY suggest being VERY careful on your car.

since it has been repainted (doesnt look stock yellow to me) you better peel up just a little bit of it and make sure the original color isnt underneath, otherwise it will look really bad. i hope thats not the case, becasue no sidemoldings would look KILLER on your car.

But, if you get the handles shaved, you'll need a re-paint, so get those side moldings off as well.

And my bags are for sale for cheap, so if you need a set up, you know where to get it.

here you go, I like this,

Bagged, molded the kit, took out the corner Vents, tinted the window, took off the spoiler, Chrome the center or the Rims,



tell me what you think[/img]

i like the front bumper and molded my widebody! but rims i dont like! good job tho

^agreed. chrome FTL on a neon.

yeh i was gonna say you should mold the wide body. makes it look 10x better.