2GN.ORG

Posted: **Wed May 11, 2005 9:19 pm**

I have been reading 2gn.org for a few days fairly regularly and decided it was time to participate.

I have had a pulsation in my brakes for a while now and i figured that everything just needed replacing (later found a lot of meat on the pads still) so i just went out and bought some cross drilled rotors and ceramic pads to replace the stock. Oh ya, and they were the cheapest rotors that Pep Boys had for the neon. haha aren't I economical.

Posted: **Wed May 11, 2005 9:21 pm**

Looks good man, just keep an eye on them for cracking.....and make sure you break them in properly.....

Posted: **Wed May 11, 2005 9:35 pm**

Ya i've been downshifting like a mother, but thats fine with me, just makes me LOUDER.

Posted: **Wed May 11, 2005 10:23 pm**

If they are really drilled and "cheap" rotors I would really keep an eye on them for cracking. Drilled rotors have a tendency to crack, depending on quality of course.

Posted: **Wed May 11, 2005 11:41 pm**

Werd. What they said.^

Posted: **Sat May 14, 2005 1:36 pm**

Nice work man!

Mitch

2GN.ORG

My "Necessary" Mod (Cross drilled rotors)

My "Necessary" Mod (Cross drilled rotors)