Because Lil' Jon and Ludacris told me to...

OB · Post by OB » Fri Apr 30, 2010 1:29 am

neonjr wrote:
OB wrote:^Damn nice wheels! Not very low though...

I'm at almost exactly 13". So in theory you are 3.25" lower than stock, assuming my springs are the 2" drop they claim. I figure they're probably within 1/8" of that. I think I'm gonna shoot for just under a 3" drop. Maybe 2 7/8" or so. Should be more than safe with the 550/450 springs I'll be getting.
Just had another look at your pictures. If that's 13 inches, i know i'm lower than that. 1 finger gap, on a angle. I was 64 cm BEFORE i lowered it more ( edge of fender to ground ) thats 25 inches. half of that is lower than you now, minus the 3/4 in or so i just dropped it. i will measure how high the pinch weld is off the ground tommorow at work.

There is no way you can only get one finger in that front gap. Even the back looks like a good 1" gap. Measure to your centercap, that's really the only way to know for sure. Keep in mind, since you have an SRT, it's already 10mm lower from the get-go.

theTeejmiester · Post by **theTeejmiester** » Fri Apr 30, 2010 4:44 am

yup, looked at the pics again, and i want the wheels even more, they just had a set on egay too, hmmmmmmm

neonjr · Post by **neonjr** » Fri Apr 30, 2010 8:35 am

OB wrote:
neonjr wrote:
OB wrote:^Damn nice wheels! Not very low though...

I'm at almost exactly 13". So in theory you are 3.25" lower than stock, assuming my springs are the 2" drop they claim. I figure they're probably within 1/8" of that. I think I'm gonna shoot for just under a 3" drop. Maybe 2 7/8" or so. Should be more than safe with the 550/450 springs I'll be getting.
Just had another look at your pictures. If that's 13 inches, i know i'm lower than that. 1 finger gap, on a angle. I was 64 cm BEFORE i lowered it more ( edge of fender to ground ) thats 25 inches. half of that is lower than you now, minus the 3/4 in or so i just dropped it. i will measure how high the pinch weld is off the ground tommorow at work.
There is no way you can only get one finger in that front gap. Even the back looks like a good 1" gap. Measure to your centercap, that's really the only way to know for sure. Keep in mind, since you have an SRT, it's already 10mm lower from the get-go.

just measured edge of fender to center cap center, 13" give or take. lmao. pinch weld is 5 inches exactly off the ground.

sidepipe87 · Post by **sidepipe87** » Sat May 22, 2010 2:00 pm

FAC3L3SS wrote: I assumed as much. Hook me up with some bazaar wheels to toss on my silver Peon, too!

As promised, I'm calling you out and correcting you. You've used the incorrect spelling of "bizarre". The "bazaar" you've spelled means some sort of sale or flea market.

FAC3L3SS · Post by **FAC3L3SS** » Sat May 22, 2010 2:05 pm

Eff me sidewards. Two times in one day?!