Part Number Request: Fuel injector O-ring

nodestiny · Post by **nodestiny** » Wed Oct 05, 2005 3:05 pm

might need to replace them, any idea? Can they be had at a hardware store?

eVilcreations · Post by **eVilcreations** » Wed Oct 05, 2005 5:52 pm

I would HIGHLY recommend just getting new ones, actual seals for your car I mean. O-Ring seals from a hardware store might not last long, or might now handle the temps/pressures of a motor. Just a thought.

Josh

turboN2O · Post by **turboN2O** » Wed Oct 05, 2005 6:44 pm

They sell and actual fuel injector kit for the Neon at any automotive store. Borg Warner (BWD) but I don't know the part #.
They are not very expensive. Be sure to lubricate the seals prior to installing.

Richard Z.

Post by **Diablo0** » Wed Oct 05, 2005 7:09 pm

Mopar Part - O RING KIT, Fuel Injector - 4897125AA - MSRP $10.70

nodestiny · Post by **nodestiny** » Thu Oct 06, 2005 10:45 am

Diablo0 wrote:Mopar Part - O RING KIT, Fuel Injector - 4897125AA - MSRP $10.70

$10.70 EACH!?! DAMN my O rings work good enough for me

Post by **Diablo0** » Thu Oct 06, 2005 12:23 pm

note that is says KIT... so it may include more than one

nodestiny · Post by **nodestiny** » Thu Oct 06, 2005 2:45 pm

If its all 4, i guess thats about right... but if its EACH... much i wouldnt be too suprised since dealerships LOVE to charge... Either way, i did beat up my injector O rings a bit, but they are still useable. Might wait a while on this one... well see.

Loud-e-nuf · Post by **Loud-e-nuf** » Wed Oct 12, 2005 7:58 pm

I have a set from a talon engine rebuild I helped with. If you PM me your address I'll stick them in an envelope theirs 8 total
________
Toyota Isis
________
FRIDAY NIGHT LIGHTS DICUSSION

03sxt · Post by **03sxt** » Thu Oct 13, 2005 5:43 pm

Like Diablo0 said, I'm sure that since it says kit, it's probably 4.

getcrunk88 · Post by **getcrunk88** » Tue May 20, 2008 4:01 pm

does anybody know the size of the o-rings on the intake side? i found a picture of them but i cant find the size.... i have a whole bunch of o-rings just need some numbers to match them up

Post by **occasional demons** » Tue May 20, 2008 11:30 pm

The only way I can tell you, is by pulling my injectors and measuring them, but you could do that, yourself. Which, I guess if no one else replies, you may need to!