Part Number Request: Wing stabilizers?

Post Reply
Midnight_Rider
Spam Avenger!
Posts: 9003
Joined: Wed Aug 02, 2006 2:49 am
Location: Kokomo, IN

Part Number Request: Wing stabilizers?

Post by Midnight_Rider » Mon Nov 01, 2010 2:46 pm

Does anyone know the name and PN for the little foam triangles that are next to each taillight? They have adhesive that sticks to the quarter panel under the trunk lid and I think that they are there for stabilizing the wings. I showed the ones on my car to the parts guys at my dealership but their online parts explosion doesn't really single them out.
Official "I'm Going To Drive My Neon 'til It Dies" Club #10

r/tguy02
2GN Member
Posts: 3644
Joined: Sat Jul 07, 2007 11:42 pm
Location: carlisle, pa.

Post by r/tguy02 » Mon Nov 01, 2010 3:31 pm

i'm a bit confused gramps, have a pic of one?
Justin
[02 R/T sold][00 Highline sold][04 r/t scrapped][95 NYG Sport coupe][01 r/t DD]
http://www.cardomain.com/ride/2931823

User avatar
sidepipe87
2009 Silver Contributor
Posts: 9516
Joined: Fri May 30, 2008 5:35 pm
Location: Pittsburgh, PA
Contact:

Post by sidepipe87 » Mon Nov 01, 2010 3:49 pm

It's just a little foam block that is glued on the top of the inside black part of the tail light to supposedly keep the trunk from moving around due to the wing. I think only 03+ got them. I could be wrong.
PM me for your 00+ PCM SKIM/VIN flashing needs. Neon PCMs Plus

r/tguy02
2GN Member
Posts: 3644
Joined: Sat Jul 07, 2007 11:42 pm
Location: carlisle, pa.

Post by r/tguy02 » Mon Nov 01, 2010 3:53 pm

oh gotcha, he confused me with triangle, he meant rectangle. Yeah mine had those as well but the sticky on it wore off and fell off. i dont think its that critical that you need to replace it gramps but if you feel compelled to do so i'd say just find a piece of foam, get some double sided sticky tape and slap one back on.
Justin
[02 R/T sold][00 Highline sold][04 r/t scrapped][95 NYG Sport coupe][01 r/t DD]
http://www.cardomain.com/ride/2931823

occasional demons
Junior Admin
Posts: 20306
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Mon Nov 01, 2010 7:59 pm

Well I cannot promise this is correct, as it is not shown in the illustration.

5008663AD STOP/BMPR DECK LID/ BUMPER, Deck Lid, Drain Trough $7.20

It is only listed in the "Spoiler - Rear Deck Lid
Figure SPL-1315" Illustration.

Maybe have your parts person look up that, in case they were looking at the tail lamp illustration.
Bill
Olha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
2021 Forester

User avatar
sidepipe87
2009 Silver Contributor
Posts: 9516
Joined: Fri May 30, 2008 5:35 pm
Location: Pittsburgh, PA
Contact:

Post by sidepipe87 » Mon Nov 01, 2010 8:29 pm

That might be the rubber screw that rests against the rubber stop on the bumper when closed.
PM me for your 00+ PCM SKIM/VIN flashing needs. Neon PCMs Plus

occasional demons
Junior Admin
Posts: 20306
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Mon Nov 01, 2010 8:40 pm

Nope, that would be the "BUMPER, Deck Lid Overslam" 5008374AB

This was shown only in the spoiler illustration.
Bill
Olha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
2021 Forester

Midnight_Rider
Spam Avenger!
Posts: 9003
Joined: Wed Aug 02, 2006 2:49 am
Location: Kokomo, IN

Post by Midnight_Rider » Tue Nov 02, 2010 4:38 am

sidepipe87 wrote:I think only 03+ got them. I could be wrong.
My '02 SXT had them- the dealership replaced them under warranty when they fell off that car (yes, I am that anal when it comes to having all OEM on the car).
sidepipe87 wrote:That might be the rubber screw that rests against the rubber stop on the bumper when closed.
occasional demons wrote:Nope, that would be the "BUMPER, Deck Lid Overslam" 5008374AB

This was shown only in the spoiler illustration.
Correct. This showed up in the parts explosion and I explained that to the parts manager.
occasional demons wrote:5008663AD STOP/BMPR DECK LID/ BUMPER, Deck Lid, Drain Trough $7.20

It is only listed in the "Spoiler - Rear Deck Lid
Figure SPL-1315" Illustration.
I'll give them the info you were nice enough to find and order a couple of sets (so I'll have some when the ones I'm putting on now rot and Chrysler has stopped having them available).
Official "I'm Going To Drive My Neon 'til It Dies" Club #10

Midnight_Rider
Spam Avenger!
Posts: 9003
Joined: Wed Aug 02, 2006 2:49 am
Location: Kokomo, IN

Post by Midnight_Rider » Wed Jan 05, 2011 5:14 am

Got two pairs. Thanks for the help! :thumbup:

Mods- feel free to lock this.
Official "I'm Going To Drive My Neon 'til It Dies" Club #10

Post Reply

Return to “PN Exterior”