Part Number Request: ECU part numbers
Part Number Request: ECU part numbers
Hello, Just bought a 2000 neon as a daily. Problem is I think it was auto and still have the auto ECU but MT conversion. So I cannot pass emissions with a CEL. Does anyone know the part number for a 2000 MT CA emissions ? W/o SKIM?
Or how can I decode? Look this up myself?
Will any of these work?
05293204AA
Unit 1
Chrysler p/n P05293224AC Module s/n T79EH221901BTO (3224AC)
Unit 2
Chrysler P/N P05033080AB Module s/n T29EH29900KYQR (3080AB)
Unit 3
Chrysler P/N P05033080AB Module S/N T29EH30000KYRE (3080AB)
#04745860
#05033068AD
#05033068AE
#05033068AH
#05033068AK
3168AR
3063AC
52691815AE Think this one is from a 99 MT
Or how can I decode? Look this up myself?
Will any of these work?
05293204AA
Unit 1
Chrysler p/n P05293224AC Module s/n T79EH221901BTO (3224AC)
Unit 2
Chrysler P/N P05033080AB Module s/n T29EH29900KYQR (3080AB)
Unit 3
Chrysler P/N P05033080AB Module S/N T29EH30000KYRE (3080AB)
#04745860
#05033068AD
#05033068AE
#05033068AH
#05033068AK
3168AR
3063AC
52691815AE Think this one is from a 99 MT
-
- Junior Admin
- Posts: 20306
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
If the CEL is for the converter lock up solenoid, The wires that go to the solenoid are Dark Blue/White and Orange/Black. So look for a connector with those two wire colors. Wire them to a relay coil, and it may get rid of the code; after you disconect the battery, or better, wait a few on/off cycles. (so the monitors are still set.)
Sometimes it can be a royal pain getting it emissions ready after the PCM has been reset.
Sometimes it can be a royal pain getting it emissions ready after the PCM has been reset.
Bill
1999 neon coupe 2.4 swap
2021 Forester
2000 Neon MTX swap with '02 R/T PCMOlha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
1999 neon coupe 2.4 swap
2021 Forester
So any SPDT relay? or buy the solenoid from the parts store?
I just ordered this ECU
Big Sticker on back
Authorized Software Update 3098AC
P/N : P05033098AC
VIN : 1P3ES46C7YD7693
It Starts, No CEL but shuts off after a second or two... is it the SKIM?
If my car has no SKIM key, can I just get one and use it with this?
on the top it says
Chrysler P/N : P05293224AC
Module S/n: T79EH04200MYKY
I just ordered this ECU
Big Sticker on back
Authorized Software Update 3098AC
P/N : P05033098AC
VIN : 1P3ES46C7YD7693
It Starts, No CEL but shuts off after a second or two... is it the SKIM?
If my car has no SKIM key, can I just get one and use it with this?
on the top it says
Chrysler P/N : P05293224AC
Module S/n: T79EH04200MYKY
The car shuting off would be the SKIM. Be aware that if you try this 3 times you will be locked out from starting the car at all.
There is no difference in a PCM for a SKIM equiped car or not. If the car has no SKIM and the PCM has never seen a SKIM signal then it won't require one. But if you take that same PCM and install it into a car with SKIM, it will forever more require a SKIM signal.
As far as the part #s you posted, none of them appear correct. As far as I can tell, the only part # that would fit the bill for you (2000 2.0, manual trans, Cal. emissions) would be 5293023Ax (the x being pretty much any letter level from M to U).
There is no difference in a PCM for a SKIM equiped car or not. If the car has no SKIM and the PCM has never seen a SKIM signal then it won't require one. But if you take that same PCM and install it into a car with SKIM, it will forever more require a SKIM signal.
As far as the part #s you posted, none of them appear correct. As far as I can tell, the only part # that would fit the bill for you (2000 2.0, manual trans, Cal. emissions) would be 5293023Ax (the x being pretty much any letter level from M to U).
If I could just figure out how to meld the Outback and the Neon into one car...
-
- Junior Admin
- Posts: 20306
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
Just a cheap SPDT relay, all it needs to see is some kind of resistance to ground/through the circuit. It doesn't even have to send a signal to the solenoid to know it is not there. I get an MTV code just starting the car. The MTV relay is not actuated until at least WOT, so I know it is not sending voltage to the relay.
Bill
1999 neon coupe 2.4 swap
2021 Forester
2000 Neon MTX swap with '02 R/T PCMOlha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
1999 neon coupe 2.4 swap
2021 Forester
woops, good thing I only tried to start it twice... My car does have the RED led top right on the dash that stays on constantly with the ECU it has now, but starts with a black key no prob for well over a month.
The new ecu, no CEL no red LED nothing... but shuts off.
But I guess its the wrong one regardless?
Ill try the solenoid... what about a resistor?
The new ecu, no CEL no red LED nothing... but shuts off.
But I guess its the wrong one regardless?
Ill try the solenoid... what about a resistor?
-
- Junior Admin
- Posts: 20306
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
You would need to know what the ohm value needs to be. IIRC Dante used 33 ohm resistors to simulate some solenoids in an SRT swap...
You could PM him, incase he doesn't see this.
You could PM him, incase he doesn't see this.
Bill
1999 neon coupe 2.4 swap
2021 Forester
2000 Neon MTX swap with '02 R/T PCMOlha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
1999 neon coupe 2.4 swap
2021 Forester
-
- Junior Admin
- Posts: 20306
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
Suckage! Since you obviously don't have a TC lockup solenoid to test. It's not something I have lying around, or I would be happy to do it.
The relay is still worth a try. I doubt one of those is going to pull as much, so it shouldn't hurt anything.
The relay is still worth a try. I doubt one of those is going to pull as much, so it shouldn't hurt anything.
Bill
1999 neon coupe 2.4 swap
2021 Forester
2000 Neon MTX swap with '02 R/T PCMOlha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
1999 neon coupe 2.4 swap
2021 Forester