Since there are no threads about the harlan switch in specific, I've decided to make one for those who choose to go this route.
Things you need:
- Magnum IM with working actuator
- Harlan switch
- Relay (5 or 4 pin)
- Wires
Let's begin:
1. First, what I did was strip the wiring from the actuator, and connected a longer wire so it could reach further. This allowed me to hook up all my wiring near the PDC. (Fuse box in the engine bay)
2. From there, I tapped into the tach reading, and also the 12 V from the coil pack. [tach = pink blue, 12v = green orange]
3. After, I made some holes with a drill inside the empty fuse spot in the PDC. This allowed me to neatly wire the relay part. I also used those clippy things that hold onto the relay pins really well. (No idea what theyre called, got them off my mpx projectors. They weren't connected cause I'm using HIDS)
4. From there I hooked up the clips onto the relay, then fed the wires through the hole I made, and put the relay in place.
5. Now, pretty much just wire it up according to the diagram.
I wired the power of the relay (85) to the power coming into the PCD (the blue wire you see). Also grounded the relay (87) and the switch to the ground right infront of the PDC. I also wired the switch to be connected to the 12v coming from the coil pack, so it only turns on when the car is on. [tach = pink blue, 12v = green orange]
Once you've got that wired up, you're good to go. I first tested with an LED and an RPM range of 2000-3000 to see if it turned on.
NOTE: Make sure you set the CYLINDERS to 2 when programming the switch. (Not 4, I repeat 2).
Here's a clip: First run was with window open, 2nd is much better and you can hear them opening at 4800
http://johnyr.net/car/butterflies%20run.MP4
How-To: Wire Magnum Intake Manifold with HARLAN switch
How-To: Wire Magnum Intake Manifold with HARLAN switch
www.JohnyR.net - Web development
yeah it was, but I followed the how to for the MSD and ended up burning my original switch so I thought I might as well as make an official one that works for this switch
www.JohnyR.net - Web development
-
- Junior Admin
- Posts: 20306
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
It is to make the MTV operate on non R/T and non ACR neons. Only the R/T and ACR's came with the PCM and wiring to control them.
Bill
1999 neon coupe 2.4 swap
2021 Forester
2000 Neon MTX swap with '02 R/T PCMOlha Koba, a psychologist in Kyiv, said that “anger and hate in this situation is a normal reaction and important to validate.” But it is important to channel it into something useful, she said, such as making incendiary bombs out of empty bottles.
1999 neon coupe 2.4 swap
2021 Forester