2GN.ORG

so when i got my srt some guy spliced all the wires for some strange reason and well im trying to make it go back to factory so i bought this metra harnes shown below....




1- 12v ignition/acc = red

2- 12v batt/memory = yellow (theres 2 yellow wires) ??

3- Ground = Black (theres 2 of these as well) ??

4- Power antenna = Blue

5- illumination = orange

6- phone mute = brown

7- right front = +gray/ - gray/black

8-left front = + white/ - white/black

9- right rear = + purple/ -purple/black

10- left rear = +green/ -green/black

11- White with a thick red stripe-???



This is the wiring i got from the sticky

A- Radio 12V pink +

B- Radio Ground black -

C- Radio Ignition red/white +

D- Radio Illumination black/yellow +

E- Left Front Speaker (+/-) green - brown/red +,

F- Right Front Speaker (+/-) purple - blue/red +,

G- Left Rear Speaker (+/-) brn/yellow - brn/lt. blue +,

H- Right Rear Speaker (+/-) blue/white - blue/orange +,



so this is how i matched them

1-C

2-A

3-B

4- ???

5-D

6-???

7-F

8-E

9-H

10-G

11-???


do i have it lined up right? and i guess i cap off what i dont use but y do i have 2 powers(yellow) 2 grnds(black) and that white and red striped? which isnt listed on the back of the metra sheet


any help would be great

you got it right, connect the 2 yellows and blacks together. also pull out the blue, brown, and white/red on the harness and you should be gtg

also PLEASE make sure the illumination goes 12v with the parking lights and dosent change voltage with the dimmer switch, this isnt the right illumination wire and it will fry a radio

edit thanks for reading my sticky

so match the orange on the harness with the black/yellow for the illumination? that should work right

yea if black/yellow is a true illumination wire, sometimes illumination and dimmer get mixed up thats why im telling you to test it first

EDIT: the 2 yellows and blacks, if there is 2 wires in the dash connect each to one, otherwise yes wire both to one.

EDIT2: if your wondering too the white/red wire on the harness is the data wire for the CAN-Bus system which none of the neons have

i greatly appreciate the infor i will test the harness on a factory radie thats broke already before i plug in my screen