here is what they look like aLLLL blue(current setup)
I didnt believe any one when they said red wouldt work so i bought 3 reds and three blues
thats why there is six total...I wanted to see how bad they would shine through and unfortunatly:(
they dont shine this next picture i put two red ones in (the one on the right and the one in the middle) and one blue in(all the way on the left) you can BARELY see the 1 knob let alone the recycle knob at all so reds=no go
How-To: HVAC Light replacement
-
- 2GN Member
- Posts: 661
- Joined: Tue Jun 19, 2007 10:27 pm
- Location: West Lawn PA
- Contact:
cool dude- thanks for thatDanteneon wrote:Well, not 1000% sure, but I don't think you can buy that gear drive separate if it is broken, Chrysler sells the whole control head. I won't be able to confirm this until Monday thoughjT wrote: now for my problem
can anyone tell me how the gear thing for the fresh air/recirculate knob is supposed to be.. i messed something up tonight (and i didnt even take the whole thing apart like this how-to) and the gear just turns and pushes in and out, im not sure what its supposed to be attached to / turning to actually function properly
As far as if it just not in place right, I would have to see a picture.
On another note, not to knock the original how-to, but I thought I'd post the FSM method of the vent removal...
Pull the vent downward
By pulling from the top, remove the outer side (it comes out easier)
And remove
While I was there, here is where I installed my center duct LED's