carpet removal with photos

[greybox]

I searched all over and even though its not too hard to do I couldn't find all the photos I wanted to have before I started-so I documented as I did it!


start with a box for all the crap you didn't expect


the 4 little screws holding the back of the console in


the 2 front screws


the door moldings, and the clips that hold them


with the console removed-access to all the shifter parts


the rear seat pulled up....thats all you do, just yank it up from the front edge


the front seat removed on one side


the torx bolts need to be taken out to remove seatbelts-too tough to do with seat belts in place


there are little plastic clips that help hold the carpet in


the carpet is tucked under the dash area, cut it as close to center and pull away from hump


carpet folded back and drivers area is now clear


both seats removed, 4 bolts each, carpet folded up and taken out back door


shifter boot has funky tab on front, boot pulls out releasing clips


seats bolted back in as I am not putting carpet back until I find leaks that caused mold to start with

[Gnuserup]

pretty nice and detailed - thanks

[akirony]

Thank you. Now I can finally get that black carpet out of the JY.

[greybox]

oh yeah, the front of the console seems wedged in there pretty good...no other screws, it just fits tight. and the shifter needs to be pushed down and turned to release it.

[Swordfish2Cowboy]

I searched all over and even though its not too hard to do I couldn't find all the photos I wanted to have before I started-so I documented as I did it!


start with a box for all the crap you didn't expect

What, like lint? Maybe a couple dead bugs? A leaf? Some small stones perhaps. A single hair?

[greybox]

uuuhhhh I wish...armor all, spare quart of oil, power steering fluid, some cds I have been looking for the aux cord so I dont rip it up....oh, yeah and that is where I put the door moldings....I think thats it....