How To: Program the Sentry sysem into a replacement pcm

Post Reply
User avatar
BlackRoseRacing
2009 Platinum Contributor
Posts: 12737
Joined: Sat Dec 25, 2004 8:58 am

How To: Program the Sentry sysem into a replacement pcm

Post by BlackRoseRacing » Tue Apr 17, 2007 5:49 am

This will require the DRBIII tool to do the following. Note, some aftermarket scan tools may be able to do the same procedure but not many of them can:
PROGRAMMING THE PCM (SBEC)

The SKIS Secret Key is an ID code that is unique to each SKIM. This code is programmed and stored in the SKIM, PCM and transponder chip (ignition keys). When replacing the PCM it is necessary to program the secret key into the new PCM using the DRB III. Perform the following steps to program the secret key into the PCM.

Turn the ignition switch on (transmission in park/neutral).

Use the DRB III and select THEFT ALARM, SKIM then MISCELLANEOUS.

Select PCM REPLACED (GAS ENGINE).

Enter secured access mode by entering the vehicle four-digit PIN.

Select ENTER to update PCM VIN.

NOTE: If three attempts are made to enter secure access mode using an incorrect PIN, secured access mode will be locked out for one hour. To exit this lockout mode, turn the ignition to the RUN position for one hour then enter the correct PIN. (Ensure all accessories are turned off. Also monitor the battery state and connect a battery charger if necessary).

Press ENTER to transfer the secret key (the SKIM will send the secret key to the PCM).

Press Page Back to get to the Select System menu and select ENGINE, MISCELLANEOUS, and SRI MEMORY CHECK.

The DRB III will ask, Is odometer reading between XX and XX? Select the YES or NO button on the DRB III. If NO is selected, the DRB III will read, Enter odometer Reading<From I.P. odometer>. Enter the odometer reading from the Instrument Panel and press ENTER.

Post Reply

Return to “HT Miscellaneous”