Harness reduction

Is your car throwing codes or are you having a hard time passing your state or county emission test? Ask how to fix it here.
Post Reply
2GN Member
Posts: 1329
Joined: Fri Feb 13, 2009 10:42 am
Location: Newark, DE

Harness reduction

Post by OhNoA2.0 » Sat Dec 28, 2013 6:36 pm

I'm looking to make a custom engine bay harness for my boosted 02 R/T, run on MS2 . I want to clean up the engine bay and the wiring mess seems to be a good place to start.

What all can I remove without throwing a CEL? I still have to pass inspection which is already going to suck trying to get around with MS and all. I just want to simplify it.
Official "I'm Going to Drive My Neon till it Dies" Club #000094

occasional demons
Junior Admin
Posts: 19494
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sun Dec 29, 2013 5:07 am

About the only thing not vital to engine management, would be the purge flow control solenoid under the brake booster. And it will give you a CEL.

There just isn't much that is not needed to run the engine - emissions wise under the hood. A 1gn would be another matter, but they really cleaned things up for the 2gn's in that aspect.

Most of it is in the rear of the car.

Technically, the entire engine management system is emissions equipment.
dblsg wrote:ya'll a bunch of post whores
Seriously people, this is 2019 not 1920.
2001 Neon ES MTX with '02 R/T PCM
Help support 2GN!

Post Reply

Return to “Emissions”