rotors??

lvlistchif · Post by **lvlistchif** » Tue Jul 18, 2006 6:01 am

do you have to adjust anything for your rotors to fit cause it seems like my rotors are a bit to big and dont fit. about a centimeter bigger than stock ones. is there anyway to fix this or they sent me the wrong size?

BlackRoseRacing · Post by **BlackRoseRacing** » Tue Jul 18, 2006 6:16 am

Are you reffering to te rotor not fitting between the pads in the caliper or are you talking about the rotor not fitting on the hub...more details are needed

lvlistchif · Post by **lvlistchif** » Tue Jul 18, 2006 6:28 am

it wont clear the hub i think its called, like 2 parts that stick out and the caliper and brake pads sit in.

J8t4m · Post by **J8t4m** » Tue Jul 18, 2006 11:38 am

Maybe take a couple pictures ?

BlackRoseRacing · Post by **BlackRoseRacing** » Wed Jul 19, 2006 6:25 am

it sounds to me like your trying to stuff an srt rotor onto a non srt setup. The Srt rotors are 3/4inch wider(bigger) than the non-srt, wich means your going to need srt knuckles to make them fit...

lvlistchif · Post by **lvlistchif** » Fri Aug 04, 2006 3:05 pm

would i only need to replace the front brake system or do i nee to replace the rear for them to fit to? i didnt test the rear.

kc2005ptgt · Post by **kc2005ptgt** » Fri Aug 04, 2006 4:09 pm

all... front and rear.

rice_eater · Post by **rice_eater** » Fri Aug 04, 2006 4:12 pm

lvlistchif wrote:would i only need to replace the front brake system or do i nee to replace the rear for them to fit to? i didnt test the rear.

the rears should fit since they are the same between R/T neons and SRTs, as long as you actually have disks in the rear to begin with

if this is a stock neon with rear drums, you have no rear caliper built into the rear knuckles, so while you can put the rotor in, there wont be anything to sqeeze it and make it stop