03 conversion on 00 Need help
03 conversion on 00 Need help
watsup guys i got hit by a lady tonight, and im goin to need a new front bumper along with a set of headlights. I need to know if i will have any problems fittin an 03 Buddyclub bumper as long as i have the 03 headlight? Will my Ip2 hood cause fitment problems becuz i kno that its a little longer than the 03 hoods. Thanks guys
-
2k2patriotblueneon
- 2GN Member
- Posts: 923
- Joined: Sun Jul 11, 2004 3:17 pm
- Location: New York State
- Contact:
It will fit there may be a tiney gap if that. Like you said important part is that you have the headlights.
2002 Dodge Neon SE
Mopar Stage 3 Coilovers w/Energy Suspension Polyurethane Bushings
SRT Swap in progress
SRT is powered by an AGP 50 trim stage 4 ball bearing turbo kit
When finished will run no less then 400 HP.

Mopar Stage 3 Coilovers w/Energy Suspension Polyurethane Bushings
SRT Swap in progress
SRT is powered by an AGP 50 trim stage 4 ball bearing turbo kit
When finished will run no less then 400 HP.

- eVilcreations
- Former Jr. Admin
- Posts: 2411
- Joined: Tue Jul 06, 2004 6:52 pm
- Location: the flatlands, KS
- Contact:
Yup, 2k2 is correct.....basically the gap will be similar to the gap on the SRT-4 with stock hood/bumper....it's very minimal.
Headlights
Bumper
Good to go.
However, if you decide to go with an SRT front....you will also either need to pick up an SRT washer fluid bottle, or remove yours totally.
Josh
Headlights
Bumper
Good to go.
However, if you decide to go with an SRT front....you will also either need to pick up an SRT washer fluid bottle, or remove yours totally.
Josh

- SolarYNeon
- 2GN Member
- Posts: 354
- Joined: Fri Jun 09, 2006 3:05 pm
- Location: Washington, DC
you dont need to remove the washer bottle. you simply could mod it,
or if you're like me, lazy, you could take the fogs (if you have them. if you dont have foglights, the bumper will go on without a problem.) and just dremel on of the bolts off. The bolt on the left side of the foglight clears the bottle, ive got mine all secured and dandy, not a problem and its been on for a LONG time.
or if you're like me, lazy, you could take the fogs (if you have them. if you dont have foglights, the bumper will go on without a problem.) and just dremel on of the bolts off. The bolt on the left side of the foglight clears the bottle, ive got mine all secured and dandy, not a problem and its been on for a LONG time.
