Taking off dash cover

Have a question that your not sure what category it fits into or isn't really a specific question about a specific part? Ask it here...
Post Reply
speedracer
2GN Member
Posts: 223
Joined: Wed Nov 02, 2005 12:54 pm
Location: Atlanta, GA

Taking off dash cover

Post by speedracer » Mon Nov 06, 2006 4:15 pm

What's up people. Anyway, other than removing the two a-pillars and the two phillips head screws, what else do I need to do to completeley remove the dash? I can pop the front off but I can't detatch it where it meets the windshield. I have the hayne's manual and read it and thier instructions on the point seem vague. According to them I should have had no trouble disengaging it, but this is not the case (especially for dumbasses like me).
'04 black sxt mtx, crane #12, p+p head, oversize valves, tti lth, iceman, magnum manifold, mpx udp
Top
Mr Josh Zombie
2010 Platinum Contributor
Posts: 8357
Joined: Tue Aug 22, 2006 8:43 pm
Location: Toledo, OH

Post by Mr Josh Zombie » Mon Nov 06, 2006 4:18 pm

in the center, where the grates for the window defrost vent is, there is two screws... one on each side

unscrew those, and you're good to go!
Modify your Car • Modify your Body • Modify your Life
Top
User avatar
bad04srt
2GN Member
Posts: 2473
Joined: Sun Apr 09, 2006 6:45 pm
Location: chitown

Post by bad04srt » Mon Nov 06, 2006 6:04 pm

^ :withstupid:
Image
Top
speedracer
2GN Member
Posts: 223
Joined: Wed Nov 02, 2005 12:54 pm
Location: Atlanta, GA

Post by speedracer » Mon Nov 06, 2006 6:35 pm

Groovy! Thx guys, can't wait to rip the mother off now! :twisted:
'04 black sxt mtx, crane #12, p+p head, oversize valves, tti lth, iceman, magnum manifold, mpx udp
Top
Post Reply

Return to “General 2nd Gen Discussion”