quite the turnsignal problem:(

spencersummerfield · Post by **spencersummerfield** » Sat Dec 02, 2006 9:12 pm

ok, a while back I did the "no more ricer" flash mod to my flashers.
it has worked fine until the other day I noticed that my left front turn signal was not working..
I jiggled the socket and it started to work just fine..

I own a 200o Neon and finally the other day again it just stopped workin all together....

so here is my problem, my front turnsignal/parking light will not blink, but all the other ones do, the back and the other front one are fine......

I took a test light to teh socket, and found that the parking light do work, the bulb lights upt fine , but will NOT blink... there is no voltage to the turnsignal wire in the socket, the parking voltage is there and teh ground is good..
so apparently i have a bad wire???

any help with this would be greatly appreciated..
and I changed the LED bulbs back to normal ones and still same problem, and switched the sockets in the front still nothing.......

Thanks
Spenny

Panhead · Post by **Panhead** » Sun Dec 03, 2006 8:14 pm

could be a fuse, check the fuses.

juvy · Post by **juvy** » Thu Mar 19, 2009 11:42 pm

I know i'm bringing this thread from the pits of hell, but I have the exact same problem right now after installing my L.E.D's. Can anyone shed light on this problem?

Left Turn Signal will not work. When I put hazards on, only the right side blinks. Only the front and rear driver side lights will not blink.