removing the spoiler

OZ10 · Post by **OZ10** » Wed Feb 02, 2005 3:45 pm

when you take it off what should I use to fill the holes left from the bolts?

eVilcreations · Post by **eVilcreations** » Wed Feb 02, 2005 11:38 pm

body filler is what most use, or just get rubber plugs to put in there.....what color is your car?

OZ10 · Post by **OZ10** » Thu Feb 03, 2005 7:56 am

Louie · Post by **Louie** » Thu Feb 03, 2005 9:08 am

i bought plugs at discount auto parts. 3/8's inch plugs. they fit snugly. but before pushing them in, paint them. Super Red II from discount auto parts is a VERY close color match. and also buy some clear silicone, and put some around the base of the plug so you dont get leaks.

JacksRevenge · Post by **JacksRevenge** » Fri Feb 04, 2005 2:10 am

i used little pieces of electrical tape, but then again my car is black

Danny_C · Post by **Danny_C** » Fri Feb 11, 2005 1:34 pm

If your looking at the proper way to do it. Sand it down, weld the holes shut, grind the welds, body filler, primer, than repaint whole trunk.

HiggySRT · Post by **HiggySRT** » Fri Feb 11, 2005 4:11 pm

On my old Neon I just used the push pins that are uesd in the trunk to keep the carpet held down. I colour matched the tops with touch up paint pushed them in and siliconed the bottom. It worked great and was a good temporay fix till I got another lid with no holes form the scrap yard.

2GN.ORG

removing the spoiler

removing the spoiler

Removing spoiler