Any head porting service recommendations?

fireantz · Post by **fireantz** » Sat Jan 13, 2007 1:08 pm

I'm thinking about picking up an R/T head and getting a good p&p job done to it but I don't really know where to go. Does anyone know of any places they can recommend from experience? Hopefully that doesn't cost an arm and a leg.

bigjosh · Post by **bigjosh** » Sat Jan 13, 2007 4:21 pm

I contacted Eddy at Fierro Racing in Arizona, he's on the other .org. I am getting a street port on a r/t head and intake manifold that I bought when I send it out at the end of the month. BTW the actual price is cheaper than what he has listed on his website.

neonpla · Post by **neonpla** » Sat Jan 13, 2007 4:34 pm

http://forums.neons.org/viewtopic.php?t=259775

PM this guy, he does good work at affordable prices..and you dont have to wait until he feels like doing the work for you.

edit: ^ are you planning on installing MS because your mods will be struggling to produce #'s with ngc.

bigjosh · Post by **bigjosh** » Sat Jan 13, 2007 6:02 pm

neonpla wrote:http://forums.neons.org/viewtopic.php?t=259775

PM this guy, he does good work at affordable prices..and you dont have to wait until he feels like doing the work for you.

edit: ^ are you planning on installing MS because your mods will be struggling to produce #'s with ngc.

I don't know if this question is directed at me, seeing as both of us have NGC neons, but if it is I am planning to do something with the tuning, but not until later on in the year. I need to see how everything runs first and need to get more money

. Depending on how much it costs to do a dyno, I might do a before and after run. I am hoping to get everything installed during spring break.

dinetuner · Post by **dinetuner** » Sat Jan 13, 2007 8:51 pm

neonpla wrote:http://forums.neons.org/viewtopic.php?t=259775

PM this guy, he does good work at affordable prices..and you dont have to wait until he feels like doing the work for you.

edit: ^ are you planning on installing MS because your mods will be struggling to produce #'s with ngc.

Mike is a personal friend and i have to say his work is insane i have seen it in person. very much worth the money same with his intake manifolds. he is also in the developing stages of a ITB set up that he will also be making and selling.