quick question

Broken Glass · Post by **Broken Glass** » Mon Feb 05, 2007 10:13 am

what is the size of the stock piping on an 2003 dodge neon sxt? thanks

2002TuRboNeoN · Post by **2002TuRboNeoN** » Mon Feb 05, 2007 11:26 am

exhaust piping im assuming our talking about...its 2.5 inches

00element10 · Post by **00element10** » Mon Feb 05, 2007 11:41 am

woah woah woah...2.5"? i dont think so...if anything you have stock piping on there it's going to be at most 2 1/4"...which is funny because everyone ran around saying it was 2 1/4 when really my exhaust was 2"

The largest pipe you'd want to PUT ON would be 2.5", right now you're prolly at 2 1/4

Broken Glass · Post by **Broken Glass** » Mon Feb 05, 2007 12:47 pm

thanks, im getting a header and such and im trying to find out the best way to do with with my vibrant muffler. the inlet on that is the stock so itd be 2 1/4 and i was hoping to have a 2.5 in header. whats the best way to run this?

00element10 · Post by **00element10** » Mon Feb 05, 2007 4:02 pm

if the header outlet is 2.5" you could get a header collector that goes from the 2.5 to 2.25" and weld everything up.

Broken Glass · Post by **Broken Glass** » Mon Feb 05, 2007 6:53 pm

is there anyway to have a high flow cat with a long tube header? i need one for emmisions but im not sure if theres enough room to fit on in there

white2000neon · Post by **white2000neon** » Mon Feb 05, 2007 7:14 pm

Yep i have one.

Broken Glass · Post by **Broken Glass** » Mon Feb 05, 2007 8:18 pm

sweet thanks. is the fit tight? i dont want to order the mpx long tubes and not be able to use em

00element10 · Post by **00element10** » Tue Feb 06, 2007 8:37 am

i had a magnaflow cat on mine with an afx lth...it's just a tad more cutting and welding than if you were going to bolt it straight up to the header.

scneonchic · Post by **scneonchic** » Thu Feb 08, 2007 11:02 am

I have a Fast fabs LTH w/ a magnaflow high flow cat also....everything fits just fine.

gilly02le · Post by **gilly02le** » Sun Feb 11, 2007 9:21 am

2.25 inches is the stock pipe diameter. base neons have the same sized piping, but no resonators, on base models the piping drops to 2 inches where the axle-back attaches.. the rt's and sxts do not have this and are 2.25 all the way.(and have a resonator)