MSD DIS 2, tach adapter, and not firing

GunmetalNeon · Post by **GunmetalNeon** » Wed Feb 21, 2007 1:34 pm

So I got an MSD DIS 2 and the tach adapter hooked up the other day... I had all the settings shut off... and the car wouldn't start... it is an older DIS 2 it has the switches, not the dials... like I said all the settings were shut off.. it turned over but wouldn't fire... any suggestions? any switches supposed to be switched on for the car to fire?

2002TuRboNeoN · Post by **2002TuRboNeoN** » Wed Feb 21, 2007 5:11 pm

did u by accident cut any wires im pretty sure the tach adapter you have to splice wires into your ignition make sure u didnt cut any of them in half or somethign liek that when you spliced them

GunmetalNeon · Post by **GunmetalNeon** » Wed Feb 21, 2007 11:40 pm

I'm going to check it out tomarrow again... By the way I have a 03 neon sxt mtx

epatchett82 · Post by **epatchett82** » Thu Feb 22, 2007 11:42 am

Either the blue or brown is basically an on/off switch. If it is grounded, the engine will crank but not ever fire because there is no spark. Make sure they are not grounded.

Also make sure you don't have the wires going to the coil pack crossed.