2.4 rod question

StreetEviL · Post by **StreetEviL** » Thu Apr 19, 2007 4:14 pm

I was wondering if the DOHC 2.4 rods and pistons are interchangable with the DOHC 2.0 rods and pistons? Like the same length and stuff!

tooslow · Post by **tooslow** » Mon Apr 23, 2007 4:13 pm

no I believe the wrist pins are in different location

OB · Post by OB » Tue Apr 24, 2007 3:41 am

doubt it, but im not positive.

fixitmattman · Post by **fixitmattman** » Tue Apr 24, 2007 9:30 pm

Definate no.

neon12sec · Post by **neon12sec** » Tue Apr 24, 2007 10:14 pm

whats the difference between the them? Also curious about swapping 2.4 pistons in my 2.0

thanks

Post by **racer12306** » Tue Apr 24, 2007 10:40 pm

edit: nevermind, didnt realize that the 2.4 got all of its extra displacement from the stroke.

edit2: according to allpar, the 2.4 rod is about a half an inch longer than the 2.0 rod. didnt look anymore indepth than that.

fixitmattman · Post by **fixitmattman** » Wed Apr 25, 2007 11:31 am

2.4 rod:
Is longer (if it fit on the stock 2.0 crank would bottom out on the head)
Has a larger crank bearing
Has a 2mm larger wrist pin

2.4 piston:
IIRC slightly different compression height
2mm larger wrist pin

neon12sec · Post by **neon12sec** » Wed Apr 25, 2007 5:10 pm

thanks for the info i thought that the 2.0&2.4 had the same rod journals

StreetEviL · Post by **StreetEviL** » Fri Apr 27, 2007 2:08 am

Thanks guys