below is the install for an srt4. i basiclly need to know what wires on our cars are equal to the wires shown in the install write up below. someone PLEASE know the anwser.
E-Manage - PCM Harness Location
Power [Red] - C1 - 11 - [Dark Blue/Red] This is a RUN-START +12v
Ground [Black] - C1 - 9 - [Black/White] Good ground, some people go straight to the battery.
Airflow In [White] - C2 - 23 - [Dark Green/Red] This is the Input of the MAP signal. This wire needs to be cut and the end going to the CAR connected here. VERY IMPORTANT
Airflow Out [Green] - C2 - 23 - [Dark Green/Red] This is the Output of the
MAP signal. This wire needs to be cut and the end going to the PCM connected here. VERY IMPORTANT
Tach/RPM [Brown] - Needs to be connected to a “tach” source such as an MSD tach driver.
Throttle Position [Gray] - C2 - 21 - [Orange/Dark Blue stripe] Throttle Position
Injector Harness
The wiring needed on the injector harness consists of:
E-Manage - PCM Harness Location
Injector Channel 1 [Blue/Red] - C2 – 14 – [White/Dark Blue] Injector Control 1
Injector Channel 2 [Orange/Red] - C2 – 13 – [Tan] Injector Control 2
Injector Channel 3 [Yellow/Red] - C2 – 12 – [Yellow/White] Injector Control 3
Injector Channel 4 [Purple/Red] - C2 – 11 – [Light Blue/Brown] Injector Control 4
Ground [Black/Red] - C1 - 9 - [Black/White] Good ground, some people go straight to the battery.
