Turbo Oil/Coolant Lines (especially the 2.0L turbo guys)

Post by **jonnymopar** » Fri Jun 08, 2007 2:28 pm

Mainly for those of you using an SRT turbo on a 2.0L, what did you use for oil and coolant lines? I'm guessing the stock SRT lines don't even come close to fitting. I'm just finishing a 2.4L turbo Stratus (non-SRT) motor and I need to buy/make some lines. Thanks for any input!

Ryanm07 · Post by **Ryanm07** » Fri Jun 08, 2007 5:16 pm

ah I just made the stuff. just tee'd into my heater core lines and used normal heater hose for coolant lines, but you could easily just swap out the hose barbs for fittings and go steel braided. And for the oil feed I used a -4an feed line from www.turbosunleashed.com with a restrictor from agp and the return i made out of -10an fittings and steel braided hose.

chasneonsxt · Post by **chasneonsxt** » Sun Jun 10, 2007 2:13 pm

I bought the stock srt 4 lines and Just used the tops that connect to the turbo and bought Hose and made my lenghts to fit and tapped into the lines oil and coolant.

Post by **jonnymopar** » Sun Jun 10, 2007 3:56 pm

How much do the stock SRT hard lines go for?