rear srt brakes a lil messed up?

speedyrb29 · Post by **speedyrb29** » Sat Jul 14, 2007 7:44 pm

ok i will get pics soon once i stop being lazy with the camra. but i stared disassembly on my rear srt brakes because i have to replace the ebrake lines.

now once i started this i notcied on each caliper one of the bolts that hold the caliper to the knuckel are bent inside the lil shaft that gose threw the rubber gromet. im guessing that not good and needs to be replaced?

also i noticed one of the pistons has a chip missing off of it...guessing i need a new caliper or pistion???

and th last thing is the lil rubber stops near where the brake lines go are damaged now what do they do? do i need to replace them too?

ewetho · Post by **ewetho** » Sun Jul 15, 2007 2:12 am

Sounds like time to get loaded calipers (which should be complete assemblies with brackets that mount to the knuckles).

Then work out form their. Remember to disassemble the calipers to lube them with High temp silicone.

speedyrb29 · Post by **speedyrb29** » Tue Jul 24, 2007 7:39 pm

heres a pic bump. think i could get away with using it?

lambostealth · Post by **lambostealth** » Tue Jul 24, 2007 10:38 pm

I wouldn't, only because it would be easier for that one to spring a leak.

speedyrb29 · Post by **speedyrb29** » Tue Jul 24, 2007 11:10 pm

mmm yea so what sould i do get a new caliper or a new piston?

Arro · Post by **Arro** » Thu Jul 26, 2007 2:42 pm

That depends, are you good at rebuilding calipers? I know guys who are, but me, I'd exchange this caliper for a loaded replacement.

speedyrb29 · Post by **speedyrb29** » Thu Jul 26, 2007 11:17 pm

what do u do bring it right back to dodge?

Arro · Post by **Arro** » Thu Jul 26, 2007 11:35 pm

OHHH these are SRT parts, damn those might be dealer only