When to reset the computer and how?

05srt4clone · Post by **05srt4clone** » Thu May 26, 2005 8:12 pm

Recently installed a CAI. Was thinking ot reset the computer because of the added cold air. Do I need to and how do I go about it?

Post by **Diablo0** » Thu May 26, 2005 8:28 pm

Won't really do much but it doesn't hurt anything. Just disconnect the battery for a little bit and reconnect it.

05srt4clone · Post by **05srt4clone** » Thu May 26, 2005 8:31 pm

Well I saw somewhere else on another board there is a button on the computer or something. That's why I was asking. While I was installing the CAI the battery was disconnected so I guess I reset it.

kevo · Post by **kevo** » Thu May 26, 2005 10:14 pm

most people will say either the negative battery terminal. Ive seen some posts where some say you can yank the fuel pump fuse for 5 minutes too.

Frizbe · Post by **Frizbe** » Fri May 27, 2005 12:52 am

kevo wrote:most people will say either the negative battery terminal. Ive seen some posts where some say you can yank the fuel pump fuse for 5 minutes too.

Fuel pump fuse for 5 Seconds will do it.

Kernel Panic · Post by **Kernel Panic** » Fri May 27, 2005 9:37 am

To completely reset the computer w/o a DRB tool, disconnect the neg terminal from the battery, while it is disconnected, turn and hold the ignition key in the start position for 30 sec. Reconnect battery term, start car, and drive.

03sxt · Post by **03sxt** » Fri May 27, 2005 3:28 pm

You can also disconnect the negative cable, get in front of your car, open the engine compartment fuse box, spin yourself around twice, blink your eyes three times, and do a handstand for no less than 4 seconds. Re-cover the fuse box, reconnect the cable and you're all set.

sxt · Post by **sxt** » Sat May 28, 2005 12:58 am

03sxt wrote:You can also disconnect the negative cable, get in front of your car, open the engine compartment fuse box, spin yourself around twice, blink your eyes three times, and do a handstand for no less than 4 seconds. Re-cover the fuse box, reconnect the cable and you're all set.

I tried that and it didn't work so I did to back flips in the middle and it worked like a champ. lol.

Baal · Post by **Baal** » Sat May 28, 2005 4:59 am

fuel pump fuse... its a yellow one.