ABS install

aperson · Post by **aperson** » Thu Aug 23, 2007 10:38 pm

I found an R/T that I'm going to be swapping engine, trans, harness, and pcm and all that way I can have the secondaries factory wired. I was wondering what I would need to put ABS and Traction control into my car. I think that the timing rings are built into the axle because when I went to replace my axle from when I got my car from the junk yard they sent me one from a car with abs and it had some weird thing on the side that goes into the tranny. Any suggestions?

aperson · Post by **aperson** » Sat Aug 25, 2007 8:49 pm

Anybody? Could somebody at least tell me where the abs sensors are? Are they in the tranny or on the wheel hub?

jmr · Post by **jmr** » Sat Aug 25, 2007 9:01 pm

Since I have done a SRT rear disc brake conversion I can tell you the rear sensors fit through the knuckles and pickup on the hub rings. Switching to ABS would be no easy task and would require ABS specific computer/master cyclinder/wheel sesor/ hub rings/proportionaing valve & pump.

aperson · Post by **aperson** » Sat Aug 25, 2007 11:45 pm

I'd end up replacing the entire harness for the car if I wanted to do this then wouldn't I?

R/T's came with ABS standard right?

Would I have to switch to rear discs if I were to do this?